Huron & SNAP Documentation

↓ Setting the RME Hammerfall as
the clock master
↓ Setting the Huron to
synchronise to the Hammerfall’s
clock
↓ Checking clock synchronisation
↓ Note: If the status indicators are
yellow, ensure the Huron been
set to synchronise to an external
clock. If the status indicators
are red, check all TOSLINK
cable connections.
WavePlayer-2 Audio Outputs in the Huron Patchbay
Controlling WavePlayer-2
OTHER SIMULATION TOOLS
• Refer to the RME documentation for instructions for setting
the RME Hammerfall to supply the master clock.
1. Click on Options/Configure menu in VRack.
2. Select External.
3. Click OK.
1. Click on the IO Manager panel in the VRack interface.
2. Check the status indicators on input channels 1 – 24. Each
channel will have a green status indicator if the clocks have
been synchronised correctly.
Audio generated by the WavePlayer-2 is accessed via the
ADAT input channels in the Huron Patchbay. The channel
mapping is shown below:
WavePlayer-2 Output Patchbay Input Channel
Channel
1 to 8 ADAT Input 1–1
to ADAT Input 1-8
9 to 16 ADAT Input 2–1
to ADAT Input 2-8
17 to 24 ADAT Input 3–1
to ADAT Input 3-8
It is not possible to directly load wave files into the
WavePlayer-2 via its VRack interface. Files must be loaded
and subsequently triggered via SNAP, with the Socket
application running on the Huron. All audio files must be in
.WAV format.
The SNAP commands to run WavePlayer-2 are described in the
Spatial Network Audio Protocol (SNAP) subsection of this
manual.
HURON TECHNICAL MANUAL PAGE 145