Huron & SNAP Documentation

Starting
↓ To access WavePlayer-2
↓ Note: Unlike most VRack
applications, the WavePlayer-2
will never show any input or
output patchpoints from within
the Patchbay.
Setting the System Sample Rate
↓ Setting the system clock rate
↓ Note: This setting will only
affect the RME Hammerfall’s
clock rate if the RME
Hammerfall is in master clock
mode (the default setting).
System Latency
↓ Setting the system latency
Setting Clock Synchronisation
OTHER SIMULATION TOOLS
The WavePlayer-2 must be loaded into the VRack through the
New/Simulation Tools submenu. (for loading instructions see
the System Tools section of this manual). Once loaded, the
WavePlayer-2 panel will appear in the VRack.
• Click on the WavePlayer-2 panel in the VRack.
The WavePlayer-2 interface will appear (see Figure 49).
The sample rate of the RME Hammerfall’s clock can be set
from within the WavePlayer-2 configuration interface.
• Select the sample rate from the sample rate drop box.
Setting a smaller buffer size will result in a smaller latency (or
delay) between calling the SNAPWP2PlayVoice command and
audio being played. Smaller buffer sizes require greater CPU
load.
• Refer to the RME Hammerfall documentation for
instructions for checking its buffer size settings.
Set the RME Hammerfall card to supply the master clock, and
set the Huron to synchronise to it.
HURON TECHNICAL MANUAL PAGE 144