SFCD: Federal Commander Digital System - Federal Signal

To RTU
Federal Commander Digital System
The format of this data entry field is three digits. To enter an RTU number of one, enter "001".
Leading zeros are required. To change To RTU, highlight the current RTU number, and then
enter a new number.
Only alarm messages that have an RTU number that is equal to or less than To RTU will be
included on this report. All Call and Zone commands "ALL" and "Z01-Z16" are included by
default.
Each RTU Separate (Yes / No)
This selection controls how the alarm messages are grouped together. To change the selection,
point & click on the radio.
If YES is selected, all alarms will be grouped together by RTU number. Within this group the
alarm messages will be in chronological order.
If NO is selected, all alarms will be printed in chronological order regardless of the RTU number.
Message Filter
The message filter determines which type of messages will be included in the report. A check
mark indicates the respective message type will be included in the report. The absence of a
check mark indicates the respective message type will not be included in the report.
Note: For Activation Log reports, the Message Filter is grayed out. If other message types are
desired, select System Log report instead of Activation Log.
Color Status
The multicolored system log provides color coded status information:
RTU Status
BLACK System Message
BLUE Reset Alarm
RED Unacknowledged Alarm
GREEN Acknowledged Alarm
Prints or displays the current status and sensor conditions of selected RTUs. Note: Current RTU
status represents the conditions of the RTU at the time of the last poll response.
64
Reports