SFCD: Federal Commander Digital System - Federal Signal
SFCD: Federal Commander Digital System - Federal Signal
SFCD: Federal Commander Digital System - Federal Signal
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Delete Message:<br />
Delete All<br />
RTU button selections<br />
<strong>Federal</strong> <strong>Commander</strong> <strong>Digital</strong> <strong>System</strong><br />
Delete highlighted message from list<br />
Delete all messages from list<br />
Controls within the RTU frame are used for sending messages to the RTU or deleting all<br />
messages currently in the RTU.<br />
Send Message<br />
Click the Send Messages button to send all messages in the Message List to the Informer-IP.<br />
Messages are sent real time one at a time in the order they appear in the Message List.<br />
Messages are assigned a Message Number based on the number of messages currently<br />
programmed in the RTU. If there are currently 3 messages, the next message will be assigned<br />
number 4 as shown above. The assigned message number will appear in the Comm Monitor<br />
following completion of the upload. To remove all messages click the Delete All button. After<br />
performing Delete All the next message will be assigned number one. Delete All may take a few<br />
seconds, wait for acknowledgement before sending new messages.<br />
Important: If you are unsure of the number of messages currently programmed, it is<br />
recommended to” Delete All” before adding new messages.<br />
Delete All<br />
Deletes all messages programmed into the RTU. The next message sent will be assigned<br />
message number one.<br />
Mute Audio<br />
When enabled messages will not be audible at the RTU during transmission. When disabled the<br />
message will playback through the RTU speaker during transmission. Warning: Mute Audio is<br />
enabled by default. Use extreme caution when sending messages with the mute audio option<br />
disabled as this could be mistaken for an actual emergency!<br />
Send Menu<br />
After selecting SEND from the Configure RTU General Parameters window, the following window<br />
is displayed. The Config and Program screens must be closed before the Send Message to RTU<br />
window will appear.<br />
151<br />
RTU