SFCD: Federal Commander Digital System - Federal Signal

Federal Commander Digital System
new time to use as the Start Time, then point & click the Save radio button to save the new Callout
Start Time.
The SFCDWARE System uses this time value (along with End Time) to determine when to
activate and deactivate the Call-out function. When the current time is equal to or greater than
Start Time, and Call-out is enabled, Call-out will be made active.
Alarm Call-out End Time (End Time)
The format of this data entry field is HH:MM, and any valid military time between 00:01 and 23:59.
Leading zeros are required. To change the End Time, highlight the current end time, type in the
new time to use as the End Time, then point & click the Save radio button to save the new Callout
End Time.
The SFCDWARE System uses this time value (along with Start Time) to determine when to
activate and deactivate the Call-out function. When the current time is equal to or greater than
End Time, Call-out is made inactive.
Alarm Call-out Time Delay (Time Delay Before Callout)
This selection applies for both weekday and weekend.
The format of this data entry field is any number between 0 and 999. To change the Time Delay,
highlight the current delay time, type in the new number of minutes to use as the delay, then point
& click on the Save radio button to save the new number.
This Call-out setup option determines how many minutes an alarm must be present without
clearing before the SFCDWARE System will originate a Call-out operation.
Alarm Setup
Alarm Setup is used for configuration of Alarms. Alarms are automatic activations scheduled to
occur on a daily, weekly or monthly basis. Holiday mode allows the normally scheduled alarm
time and function to be overridden on selected holidays. Up to 60 alarms may be configured.
Note: This dialog should only be used by specially trained administrative personal. Incorrect
settings in this section could cause sirens to inadvertently sound when not desired.
116
System Setup