SFCD: Federal Commander Digital System - Federal Signal
SFCD: Federal Commander Digital System - Federal Signal
SFCD: Federal Commander Digital System - Federal Signal
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Federal</strong> <strong>Commander</strong> <strong>Digital</strong> <strong>System</strong><br />
Use the Select Zone spin control to select the desired zone. A maximum of 99 zones may be<br />
configured in dynamic mode or 16 in conventional mode.<br />
Adding and removing sites<br />
To add sites to the selected zone, highlight the desired sites in the site selection list box on the<br />
left and click Add. To remove a selected site, highlight and click Remove. Click Remove<br />
All to remove all sites from the selected zone.<br />
The currently selected zone configuration is automatically saved when scrolling to another zone<br />
or closing the zone setup window.<br />
Voice Setup (Call-in and Call-out)<br />
Call-in and Call-out are both functions that alert key support personnel to the current status of<br />
The <strong>Commander</strong> <strong>SFCD</strong>WARE <strong>System</strong>. Both functions require the use of a touchtone telephone<br />
line. Pushing the appropriate buttons on the touchtone keypad enters actions and responses to<br />
the messages announced through the voice modem. Call-in and Call-out works similar to a voice<br />
mail system. Simply listen to the voice menus and respond with touchtone digits as desired.<br />
Call-in<br />
Call-in is initiated by dialing the phone number of the line connected to the CCU. The CCU is<br />
programmed to answer the call following a programmable number of rings. The user will be<br />
prompted to enter a password before accessing the system. Any password that is currently in the<br />
call list for any username will be accepted for the Call-in function. Note: Wait for the voice prompt<br />
to end before entering password.<br />
After a valid password is entered, the user may listen to all current alarms in the system. The user<br />
may also Acknowledge Alarms in the system.<br />
Call-out<br />
Call-out is initiated by the <strong>SFCD</strong>WARE <strong>System</strong> software when an alarm condition occurs that has<br />
been selected to call out (e.g. Intrusion) and is not Acknowledged or Reset before the Call-out<br />
Time Delay expires. The Call-out sequence is based on a user priority level from 0-9 with 0 being<br />
the highest priority. There must always be at least one 0 level priority user to enable the Call-out<br />
feature to operate. For the Call-out function, only the password associated with the phone<br />
number called will be considered valid. If the key support person who answers the call<br />
acknowledges even one alarm, the calling sequence is terminated and no other users will be<br />
called until the next Alarm event occurs. If no alarms are Acknowledged, the <strong>SFCD</strong>WARE<br />
<strong>System</strong> will initiate another Call-out in five minutes to the phone number associated with the next<br />
higher priority number, providing the Alarm that triggered the Call-out has not cleared in the<br />
meantime.<br />
114<br />
<strong>System</strong> Setup