SFCD: Federal Commander Digital System - Federal Signal

Federal Commander Digital System
This selection will cause siren dot locations to be linked to the host. Select this option if the
screen resolution of the client is the same as the host. Recommend setting.
RTU dot locations independent of host (SfcdwareClient Only)
If the screen resolution of the client is not the same as the host, siren dot locations may appear in
the wrong location. This option will allow clients to place siren dot on the map independent of the
host. Use this option only if it not possible to use the same resolution setting as the host.
Preserve Aspect Ratio
Preserve the aspect ratio of map when it is resized to fit your monitor.
Fill Screen
Resize the map to fill the entire screen. This setting may result in distortion if the aspect ratio of
the map is different than your monitor.
Native
Native mode displays the map in its native size and will not be resized to fit the screen. This
option should not be used unless the bitmap files are very close in size to the resolution of your
monitor.
Image Quality
For best quality bitmap files should be larger or equal to the resolution setting of your monitor.
Files that need to be expanded to fit the screen will result in a poor quality image.
Add Bitmap
To add a bitmap to the list of maps for display on the interactive map screen, click the Add Bitmap
button. The following dialog box will pop-up:
Highlight the desired file using point and click. Click Open to finalize your selection.
111
System Setup