MKS Implementer 2006 Administration Guide

Chapter 5: MKS Integrity Integration
254
4 In the Issue Management System field, specify the current issue management system for
this user. This field is only used when co-existing to allow certain users to use
MKS Integrity while others use DesignTracker; otherwise, input is protected.
When you activate MKS Integrity, all users are set to use MKS Integrity. Change this
value only to set the user’s default to DesignTracker and to change it back to
MKS Integrity (1=Default) when DesignTracker is no longer used by the user.
1=Default: The user is using the default issue management system as defined on the
MKS Integrity Setup panel. This is the default value.
2=DesignTracker: The user is using DesignTracker, even if MKS Integrity is the
default issue management system as defined on the MKS Integrity Setup panel.
5 Press ENTER to update the information.
IMPORTANT
After changing this value for a user, the user must sign off the iSeries and sign
back on for the change to take effect.
If this user checks out or promotes using Implementer’s Web interface, you must
restart the Web server to recognize the new issue management system. For
information on the Web interface, see “Web-based Development for IFS Objects”
on page 155.
The conversion from DesignTracker to MKS Integrity is complete. If you need to convert
existing DesignTracker data, see “Converting DesignTracker Data to MKS Integrity” on
page 431. If you do not need to convert DesignTracker data, you can begin using the
integration as described in the MKS Implementer 2006 User Guide.