User Manual

1
3 4
5
7 8
9
2
6
74
Setting CAMERA model and options
These settings are only available when the digital capture unit
is not attached to an H3D II body.
Proceed as follows:
1. Press the menu (MENU) button to open the menu.
2. Use and to select the SETTINGS sub-menu.
3. Press to open the SETTINGS menu.
4. Use and to select CAMERA.
5. Press to open the CAMERA menu.
6. Press either the + or – button to select camera model.
7. Use and to select EXPOSURE TIME or CAPTURE SEQ.
if required.
8. Press either the + or – button to make new settings if
required.
9. Press the menu (EXIT) button to exit the menu system and
keep your settings.
Options available for PINHOLE and FLASH SYNC
Shutter Delay
The normal setting is Default and cannot be changed.
Exposure Time
This setting should be changed for cable-free exposure times longer
than 1/8 second, ensuring that it matches the shutter speed/exposure
time on the camera/lens. The settings range from 1/8 second
to 32 seconds (1/8 second is the default setting).
Capture Sequence
This feature functions in the same manner as an interval timer.
Initial delay: Controls the amount of time required to elapse
before the first capture.
Delay: Controls the amount of time required between each
capture.
Count: Controls the total number of captures required.