User Manual

More documents

Recommendations

Info

16 15 Viewfinder screen showing composition frame marking (22/39/50MPix). 17 Viewfinder screen showing composition frame marking (31MPix). 22 Battery status (rechargeable battery only) 15 An immediate full-screen information and battery status check appears on the grip display by holding down the illumination/ battery status button. This screen displays: • the firmware version • the number of captures taken since the last battery recharge / change. • a rechargeable-battery status icon that provides a quick visual check as well as a figure estimate in percent. The information regarding the number of captures taken is intended to help you make an estimate of the number of possible remaining captures according to your way of working. For example, if you regularly browse a great deal when shooting or you leave the camera in ON-mode with no standby, you would naturally expect to drain the battery sooner than others who don’t. You should soon be able to build up a picture of how you usually work and can therefore estimate that after X number of captures, you normally expect to be able to take Y captures before the battery is exhausted (when working in a similar manner in similar conditions). The percentage information, however, provides another kind of estimate based more on the amount of power left in the battery rather than on your normal way of working. Remember that these are only estimates and that there are a number of factors affecting remaining battery, ambient temperature for example, as well as general practice. Viewfinder screen 16, 17 The H3D II is fitted with a Spherical Acute-Matte D viewfinder screen for extreme brightness, clarity and even illumination. An optional accessory screen with a grid pattern is also available. To change a viewfinder screen, remove the viewfinder to access the viewfinder screen. To remove the screen, place the tip of a ballpoint pen or similar in the viewfinder screen removal lug and pull upwards. To replace the screen, position the right side of the screen in place so that it sits correctly in the recess. Place the tip of a ballpoint pen or similar in the viewfinder screen replacement indentation and press downwards until the screen snaps into position. Try to avoid touching either surface of the screen with bare fingers. Do not attempt to clean the screen by immersing it in water, or use any kind of cleaning fluid. If the screen becomes damp, do not use hot air to dry it. Use a soft cloth on the upper surface only. Seek advice from an Authorized Hasselblad Service Center if the screen becomes particularly soiled. Remember that particles or greasy marks on the screen might impair the viewfinder image but have no effect whatsoever on the recorded image.
18 20 21 19 22 23 Accessory connection 18, 19 On the left hand side of the camera body are two accessory-retaining screw threads (M5), as well as a databus connector, protected beneath a cover. The cover can be removed by inserting a pointed object, such as a pen, in the small hole and then sliding it to the left, as in the illustration. The cover-retaining clip can then also be removed to access the connector. PC-connector 20 A PC connector for non TTL-flash synchronisation is located on the left side of the body. It is protected by a captive rubber plug. Protective base plate 21, 22 To attach the protective base plate, slip it over the camera foot until it stops. To remove it, lift the securing catch while pushing the plate back as in the illustration.
Page 1 and 2: User Manual H3D ll
Page 3 and 4: Deleting images 52 Transferring ima
Page 5 and 6: shutter speeds up to 1/800s. The ce
Page 7 and 8: Computer system requirements Digita
Page 9 and 10: Below is an overview of the primary
Page 11 and 12: Examples Some buttons have a toggl
Page 13 and 14: Menu charts - general Throughout th
Page 15 and 16: J K L M N O On the rear of the grip
Page 17 and 18: Customizable button function list
Page 19 and 20: 1 2 3 5 6 7 1A B C 4 19 Carrying st
Page 21: 9 10 11 12 13 14 Camera battery war
Page 25 and 26: 1 2 A B C D E F G H A. Rubber eye c
Page 27 and 28: 1 A B C D E 3 5 6 2 4 2 1 27 Parts
Page 29 and 30: 1 2 HC 3.5 / 300 A B Landscape orie
Page 31 and 32: In very simple terms, a digital cap
Page 33 and 34: Approval / (OK) button F This butto
Page 35 and 36: MENU STORAGE SETTINGS By using the
Page 37 and 38: Storage & Shooting Image storage mo
Page 39 and 40: 1 2 3 4 2 1 39 Removing a card 1. O
Page 41 and 42: 7 Storage overview- working with me
Page 43 and 44: 1a 1b 2 3 4 5 6 7 8 9 Example: nine
Page 45 and 46: Note that some shots may trigger th
Page 47 and 48: 8 Overview of viewing, deleting and
Page 49 and 50: Full-screen preview mode Battery sa
Page 51 and 52: 4 5 6 7 Full Details Mode 4 In full
Page 53 and 54: 9 Menu: • ISO • White Balance
Page 55 and 56: 1 2 3 4 5 6 1 3 ISO/WB ISO/WB Save
Page 57 and 58: 1a 1 3a There are seven ‘White Ba
Page 59 and 60: 1 2 3 Browse filter shortcut ! Th
Page 61 and 62: 1 3 4 5 2 6 Delete shortcut ! Se
Page 63 and 64: 5 6 1 2 4 3 63 5. You now return
Page 65 and 66: 1 2 3 4 5 65 FORMAT The camera
Page 67 and 68: 1 2 3 4 67 Navigating the STORAG
Page 69 and 70: 1 2 3 4 69 DEFAULT APPR. LEVEL Th
Page 71 and 72: MAIN MENU > SETTINGS > User Interfa
Page 73 and 74:
The CAMERA item on the menu remains
Page 75 and 76:
1 2 3 4 5 6 7 8 9 10 75 Setting EXP
Page 77 and 78:
1 2 1 2 77 MAIN MENU > SETTINGS
Page 79 and 80:
12 Light Metering & Exposure Contro
Page 81 and 82:
1 1 EXP EXP 2 3 2 3 R ISO / WB Save
Page 83 and 84:
1 3 4 5 ISO/WB R ISO/WB Save 2 F 83
Page 85 and 86:
1 2 3 5 A +/- B ISO / WB Save Custo
Page 87 and 88:
Power The camera can be set at two
Page 89 and 90:
1 AF 2 3 F ISO / WB Save 89 Continu
Page 91 and 92:
1 2 3 1 2 3 4 5 ON•OFF PROFILES/E
Page 93 and 94:
General overview of camera menu Sel
Page 95 and 96:
1 2 MENU 3 4 ISO/WB Enter 5 6 ‘De
Page 97 and 98:
1 3 5 7 MENU Number of captures hig
Page 99 and 100:
1 2 MENU 3 4 ISO/WB Enter 5 6 ISO/W
Page 101 and 102:
Magazine exposure lock 10 • No
Page 103 and 104:
Low flash warning 27 • On • Off
Page 105 and 106:
1 2 3 4 5 6 7 8 105 Changing text -
Page 107 and 108:
1 3 5 MENU ISO / WB Enter ISO / WB
Page 109 and 110:
The H3D can be used together with m
Page 111 and 112:
1 2 FLASH 3 4 ISO/WB Save 5 6 AE-LL
Page 113 and 114:
17 Front view Rear view TILT and sh
Page 115 and 116:
HC lens range HCD 4/28 mm HC 3.5/35
Page 117 and 118:
18 Appendix Glossary of Terms P a
Page 119 and 120:
OTF Off The Film - the original lit
Page 121 and 122:
Aperture Aperture Automatic exposur
Page 123 and 124:
User interface Battery grip recharg
Page 125 and 126:
1 2 3 B C A Care and maintenance of
Page 127 and 128:
Problems, Equipment Care & Service
Page 129:
Hasselblad A/S Hejrevej 30, DK - 24
show all

User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?