Thermo Ramsey - Hoferick Engineering GmbH

Maintenance
• YES – if the operator selected yes, the screen above displays.
Enter the actual material weight in the same weight unit’s setup in the
Integrator.
Example: Convert pounds to nearest hundredth (0.01) of a ton and enter
the result if the Integrator is set up for tenths (0.1) of a ton increments.
Material Calibration is running at 10 times normal.
• Press ENTER
ABORT – if abort is selected the information acquired during the test is
lost and the system returns to MAIN MENU 1.
7. Updating the Span Constant
After the amount of material has been entered, the following screen displays:
MAT’L CAL. COMPLETE
Error 000.00 %
change span?
YES NO ADV
Complete flashes
YES: see Section 8
ADV: changes from Error % to Actual Difference of Total
NO: moves to the following screen:
MAT’L CALIBRATION
Add reference
weight to totals?
YES NO
Yes: the reference weight is added to the totals and the Integrator returns to
MAIN MENU 1
NO: returns to MAIN MENU 1
8. Acquiring the Material Factors
If yes was selected at the Updating the Span Constant screen, the following
screen displays confirming the new span constant was installed.
SPAN # CHANGED
New span # 000000
Old span # 000000
RUN MENU FACTOR
Thermo Fisher Scientific Maintenance 3-21
REC 4175 Rev B