Thermo Ramsey - Hoferick Engineering GmbH

3.6 Normal Power On
Maintenance
When the Integrator is powered on after initial programming, the Run menu is
displayed unless the hardware configuration has been changed.
00000000 TONS
Z 000000 Tph
3.6.1 Hardware Configuration
If the hardware configuration detected at power on differs from the one recorded
in memory, the following screen displays. This only happens if a circuit board
has been added or removed during power off, or a board has failed.
--SLOT # n CHANGED
Acquire new
configuration?
YES NO
This screen disappears after 10 seconds if the question is not answered. The
Integrator assumes the answer is NO. “HW CONFIG. CHANGED” alarm is on
and cannot be reset. The above screen appears each time power is cycled. If a
board is removed or added, and this is a permanent change in configuration,
answer YES.
1. A board is removed and is not replaced:
The Integrator cancels from memory the setup data of the board that is
removed. If the board is added again, the setup data for the board has to be
entered again.
2. A board is added:
The Integrator acquires the new hardware configuration. Setup data for the
new board must be entered.
Note: Check the setup configuration in the I/O DEFINITION SCROLL if an
I/O board is removed or added. I/O assignments change when the number of
I/O boards change.
Thermo Fisher Scientific Maintenance
REC 4175 Rev B
3-5