Thermo Ramsey - Hoferick Engineering GmbH

Operation
2-38
• If # of Load Cells is 6:
-- SC DATA SCROLL –8F-
Load cell #6 res
350.000 Ohms
ENTER
Default: 350 Ohms
Min: 10 Ohms
Max: 2000 Ohms
2.9.4 Defining the Speed Input
The speed input screen allows the operator to select the single speed sensor
input (default value) or a simulated value using an internal timer.
Simulation allows operation without a speed sensor. When simulated speed is
selected, a conveyor running input is required (refer to the field wiring diagram).
Note: If speed is selected as the third line display, the line will be blank in RUN
mode when simulated speed is selected.
-- SC DATA SCROLL –9-
Speed input
> single <
CHOICE ENTER
Default: SINGLE
Choice: SINGLE, SIMULATED
2.9.5 Defining the Calibration Test Duration
Zero and Span Calibrations are more accurate if executed on an entire belt
revolution or multiple of it. Press either ACQUIRE or MANUAL, ACQUIRE is
the recommended selection. For MANUAL, see Section 2.9.8.
-- SC DATA SCROLL –11-
Establish test
duration
ACQUIRE MANUAL
Operation Thermo Fisher Scientific
REC 4175 Rev B