Thermo Ramsey - Hoferick Engineering GmbH

2.8 Selecting the Weighbridge Model
Thermo Fisher Scientific Operation
REC 4175 Rev B
Operation
By entering the code number of your Thermo Scientific scale on the next screen,
the Integrator automatically calculates parameters of the system such as number
of load cells and number of weigh idlers. This entry is also used for internal
calibration calculations. The default model number is 1, which corresponds to
belt scale model 10-20-1.
-- SC DATA SCROLL 2--
Belt scale code
> 1 <
CHOICE ENTER
Default: 1
Min: 0
Max: 500
Press ENTER to accept the displayed selection from the database listed in
Appendix A/1, Weighbridge Parameters. If ENTER is used, the scrolls from
3A to 3J are not displayed. Skip to Step 12.
Press DETAIL if you want to force the following scrolls #3A to 3O to be
displayed even if ENTER was used.
Enter 0 if you want to define the weighbridge not using the database. This
should only be done for special weighbridges that are not part of the standard set
of Thermo Scientific scales. Entering 0 forces the following scrolls 3A to 3O to
be displayed.
2.8.1 Detailing the Mechanical Parameters of the Frame
The following screens are only displayed if OTHER or DETAIL was pressed.
Refer to. The information in the following section is that which was recorded
earlier in Section 2.6.
2.8.1.1 Parameter LA: pivot to Load Cell Distance
The distance from pivot to load cell should be measured to within 0.032 (1/32)
inch (1 mm).
2-29