Thermo Ramsey - Hoferick Engineering GmbH

Operation
7. All additional field wiring operation at voltages less then 30 V must be
located on the left bottom of the enclosure. Leave ample loose wiring
(typically 8”) to facilitate removing the terminal connectors.
8. Close the inside panel and tighten the screw to secure the cover.
Figure 2-3: Field Mount Inside Front Panel
2-6
A90869
2.4 Panel Mount Installation
The panel mounted Integrator is suitable for mounting in a control panel. The
control panel should not be exposed to excessive vibration, heat, or moisture.
The front bezel, when properly seated, forms a dust seal.
A two (2) inch clearance around the top and bottom of the Integrator is required
for convection cooling. Additional clearances may be required if equipment
mounted directly below generates excessive heat. Clearance in the back is
necessary for wiring access and fuse replacement. Clearance on the side is
necessary for inserting the chassis holding brackets from the back after insertion
of the Integrator.
2.4.1 Mounting
Provide a cutout in the panel and insert the Integrator after removing the
holding brackets. From the back, insert the holding brackets on both sides of the
Integrator. Tighten the holding brackets to support the Integrator and form the
dust seal.
Operation Thermo Fisher Scientific
REC 4175 Rev B