Thermo Ramsey - Hoferick Engineering GmbH

Maximum Non-Destructive Input Voltage
150/300 VAC for 1 minute
Over voltage Category
Category II
DC Power Supply
Auxiliary Power Supply Output (Alarm Contacts, etc.)
Output voltage: 24 VDC
Isolation: Yes – 500 volts
Output ripple: 1.0 V peak to peak typical
Output current:
Short circuit protection
600 mA maximum
Thermo Fisher Scientific Installation
REC 4175 Rev B
Installation
Load Cell (Weight)
Load cell input circuits
Number: Up to six (6) 350-ohm load cells in
parallel. Cable distance 200 ft or
less (3000 ft with sense)
Sensitivity: 0.5mV/V to 3.5 mV/V (keyboard
selectable)
Input Impedance: 100 k-ohm minimum
Maximum Usable Signal: 114% of 3mV/V
Displayed A/D counts (3mV/V):112368
Isolation: Non-isolated
Max non-destructive input voltage: ± 6 V relative to ground
Load Cell Cable Shield: Connected to earth ground
Load Cell Excitation Power Supply
10 VDC ±10%, 220 mA
Minimum load impedance (operating) 58 ohms
Output short circuit, 1.5 A maximum
Excitation-Sense Circuitry
6 Wire System; cable distance over 200 ft. (not to exceed 3000 ft.).
Nominal input voltage: ±5 VDC (10 volts)
Input impedance: 100 k-ohm minimum
Jumper selectable: Local or remote sense
Speed Input
Optically isolated
Built in current source for dry contact use
Powered by + 20 V SPU Supply
1-9