Thermo Ramsey - Hoferick Engineering GmbH

Minor Calibration
If the number of calibration selected is greater than 1, the scale symbol is added
in the run display with the active calibration number, as indicated below.
E.2. Selection of Calibration Point
123.0 Tons
0.0 Tph
From 1 to 10 different calibrations can be programmed into the Micro-Tech
3101 Integrator. After selecting the number of calibrations as outlined in
Section E.1, it is necessary to determine which calibration corresponds with a
particular operating mode.
The calibration number can be activated via the front panel keyboard or through
a remote digital input.
E.2.1. Front Panel Keyboard
To change calibration number from the front panel keyboard, press the soft
key associated with the scale symbol. The following screen displays:
SELECT CALIBRATION
Calib. Number
1
ENTER
Use the keypad to enter the calibration number to be activated
Press ENTER
The active calibration number is now in the lower left hand portion of the
screen. If an auto or manual zero or span is performed at this time, only the
active calibration number is affected.
Note: If digital inputs are assigned to select calibration numbers, the calibration
number cannot be changed via the front panel keyboard. Attempting to do so
results in the following screen being displayed:
Selection calib.
In remote mode
1
Return
E-2 Minor Calibration Thermo Fisher Scientific
REC 4175 Rev B