Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.12.2. Print
The Micro-Tech 3101 has a fully programmable printer format. The following
section explains how to program it according to the specific needs.
1. Define Handshaking
The system can be configured to operate without a handshake (NONE), or
using the Clear to Send signal (CTS) or the XON-XOFF sequence. Refer to
the printer instruction manual to define which selection is required. The
selection NONE is only used for testing purposes. It is not recommended
for normal use. If NONE is selected, the system is not able to recognize if
the printer is on line or not, or if the paper is empty.
The most commonly used protocol is the CTS, which is a signal generated
by the printer to indicate whether it is ready to receive data or not.
-PRINTER SCROLL 1 -
Handshaking
> None <
CHOICE ENTER
Default: NONE
Selections: NONE, CTS, XON-XOFF
Different printers use different end of line patterns. Select the one you need for
your printer.
-PRINTER SCROLL 2 -
End of line
> CR <
CHOICE ENTER
Default: CR
Selections: CR, LF, CR+LF
Some printers cannot accept characters while they are printing. In some cases,
the handshake is not well controlled by the printer, so a delay at end of line is
helpful.
-PRINTER SCROLL 3 -
Delay end of line
0 sec
ENTER
Default: 0 sec
Min: 0 sec
Max: 5 sec
Password: Service
Password: Service
Password: Service
A-70 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B