Thermo Ramsey - Hoferick Engineering GmbH

Menus
WARNING
CHANGING THE DEFINITION OF THE DIGITAL
OUTPUTS MAY CAUSE MACHINERY TO START AFTER
THE USER TRIES TO CHANGE A DEFINITION. THE
FOLLOWING MESSAGE IS DISPLAYED.
IF THE USER PRESSES CONTINUE, BE AWARE THE
ACTION MAY CAUSE DAMAGE OR INJURY. IF THE
USER PRESSES ABORT, THE SYSTEM RETURNS TO
THE PREVIOUS SCROLL.
A.10.7. Define Remote Totalizer Output
If the TOTALIZER output function is assigned to an output, the following
screens allow the user to set up related parameters. Set the divider according to
the maximum rate the scale will run. The divider is entered in Totalization units
(T.U.). The pulse frequency generated in normal conditions should not exceed
10 Hz. Higher frequencies are possible, however they do not improve accuracy.
Default: 1
Min: 0.01
Max: 100
Enter the pulse width in seconds of the Totalizer. A higher pulse width limits
the maximum frequency. The default 0.1 sec is recommended for frequencies
lower than 5 Hz.
Default: 0.1 sec
Min: 0.005 sec
Max: 1 sec
WARNING
EQUIPMENT MAY START
CONTINUE ABORT
- I/O DEF SCROLL 6 -
Remote counter div.
1
ENTER
- I/O DEF SCROLL 7 -
Remote counter pulse
width 0.100 sec
ENTER
Password: Service
Password: Service
Thermo Fisher Scientific Weighbridge Physical Parameters A-59
REC 4175 Rev B