Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.7.6. Partial Test Duration Acquisition
If PARTIAL is pressed, the operator is asked to enter the length between two
marks on the belt.
Pressing ABORT returns the screen to CAL DATA SCROLL 11.
Press DONE when
ready.
0000 secs 000 revs
ABORT DONE
English/Mixed Metric
Default: 200.0 Ft Default: 50.0 m
Min: 1.0 Ft Min: 0.5 m
Max: 1000.0 Ft Max: 3000.0 m
After the length of the belt has been entered, the system automatically moves to
the following screen, which prompts the operator to press START when the
mark passes the reference point.
NOTE: The belt must be running at the maximum speed before executing this
function. If not, the prescaler is improperly calculated.
Pressing ABORT returns the screen to CAL DATA SCROLL 11.
Start belt. Press
START when 1 st mark
passes reference.
START ABORT
When START is pressed, the system automatically moves to the next
instructional screen. The operator presses COUNT each time a mark passes the
reference point until both marks have passed. Then press DONE.
Pressing ABORT returns the screen to CAL DATA SCROLL 11.
Press COUNT each
time a mark passes.
00000 secs 000 revs
COUNT ABORT DONE
Note: The COUNT key is not displayed if the clip detector option is in Auto
mode.
A-34 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B