Thermo Ramsey - Hoferick Engineering GmbH

Menus
When START is pressed, the system automatically moves to the next
instructional screen. The operator presses COUNT each time the mark passes
the reference point until minimum test load conditions are met (refer to the belt
scale installation manual for minimum test level requirements). When the last
revolution passes the mark, the operator must press COUNT followed by
pressing DONE.
Pressing ABORT returns the screen to CAL DATA SCROLL 11.
Press COUNT each
Time a mark passes.
00000 secs 000 revs
COUNT ABORT DONE
ABORT returns the screen to CAL DATA SCROLL 11.
When test duration is finished, the new values for length of belt and time are
displayed. Press CONTINUE
TEST DURATION
Length = 0000.0 Ft
Time = 000 SEC
CONTINUE
A.7.5. Auto Cont Belt Revolutions
If a clip detector is installed and clip detector mode in I/O Definition is set to
"AUTO", the system automatically counts belt revolutions without the need for
pressing the COUNT key. The two screens for Acquiring Test Duration are
displayed as follows:
Start belt. Wait
until 1 st mark
passes reference
ABORT
When the mark passes, the system automatically moves to the next instructional
screen. The system counts each time a mark passes the reference point until the
operator presses the DONE key.
Press DONE when
ready.
0000 secs 000 revs
ABORT DONE
Thermo Fisher Scientific Weighbridge Physical Parameters A-33
REC 4175 Rev B