Thermo Ramsey - Hoferick Engineering GmbH

Menus
Note: This option should only be used when belt length exceeds 1000 feet.
ACQUIRE TEST DUR
Choose belt length
measurement method.
FULL PARTIAL
FULL is the recommended selection.
A.7.4.2 Full Test Duration Acquisition
If FULL is pressed, the operator is asked to enter the length of one belt
revolution. Enter the length recorded in Section 2.5.1. Measure belt length to
the nearest 0.1 feet.
Enter length of one
belt revolution.
Length 1000.0 Ft.
ENTER ABORT
English/Mixed Metric
Default: 1000.0 Ft Default: 200.0 m
Min: 1.0 Ft Min: 0.5 m
Max: 10000 Ft Max: 3000 m
After the length of the belt has been entered, the system automatically moves to
the following screen, which prompts the operator to press START when the
mark passes the reference point. Pressing ABORT returns the screen to CAL
DATA SCROLL 11.
Note: The belt must be running at the maximum speed before executing this
function. If not, the prescaler will be improperly calculated.
Start belt. Pres
START when 1 st mark
passes reference.
START ABORT
Password:
Service
Note: If a clip detector is installed and clip detector mode is set to ‘AUTO’ in
I/O DEFINITION SCROLL skip to Section A.7.5.
A-32 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B