Thermo Ramsey - Hoferick Engineering GmbH

Menus
The scroll displays the date of the last calibration and the expected date of the
next one, based on the entry in the previous screen.
-- CAL DATA SCROLL 9--
Calibration date
Last: MM-DD-YYYY
ENTER: MM-DD-YYYY
A.7.3. Entering Material Factors
The material factor is a number in percent, which is used to correct the
CALCON to the real value. Entering 0 makes the material factor INVALID.
-- CAL DATA SCROLL 10--
Material FACTOR
00.00 % R-Cal
ENTER ± NEXT
Default: 0 %
Min: -99.99%
Max: +99.99%
NEXT scrolls between material factors of R-Cal, Weights, and Chains
“INVALID” displays if they have not been measured
A.7.4. Defining the Calibration Test Duration
Zero and Span calibrations are more accurate if executed on an entire belt
revolution or multiple of it. Press ACQUIRE (the recommended selection) or
MANUAL (skip to Section 888A.7.4.)
-- CAL DATA SCROLL 11--
Establish test
duration
ACQ MANUAL
ACQuire is the recommended selection.
A.7.4.1 Acquiring the Test Duration
When selecting FULL, use a 100-foot tape to measure the belt length to the
nearest 0.1-foot. Reference a fixed point (an idler) on the conveyor when
counting belt revolutions. See Section 2.5.1 for the recorded conveyor belt
length.
The PARTIAL (belt length measurement) selection enables the operator to
acquire test duration without the entire belt length measurement.
Thermo Fisher Scientific Weighbridge Physical Parameters A-31
REC 4175 Rev B