Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.7.1.3 Detailing the Test Weight Parameters
This section only applies if TEST WEIGHTS mode was selected as the
preferred method. Enter the weight of the test weights used for calibration.
English/Mixed Metric
Default: 0.000 Lbs/Ft Default: 0.000 kg/m
Min: 0.000 Lbs/Ft Min: 0.000 kg/m
Max: Load cell size x no
of load cells
Max: 3000 kg/m
The system calculates the CALCON (Calibration Constant) based on the
mechanical and electrical parameters entered in the SCALE DATA. This menu
is for reference only.
A.7.2. Entering a Calibration Interval
The system can be programmed to prompt the operator when the next calibration
is due. If this option is not desired, confirm the default 0 days interval,
otherwise enter the number of days. The calibration date displayed in Scroll 9 is
automatically updated whenever a calibration is performed. If a non-zero value
is entered, an alarm appears after the time is elapsed. The alarm can only be
cleared after a calibration check is executed.
Default: 0 Days
Min: 0 Days
Max: 365 Days
-- CAL DATA SCROLL 6 --
Total test weight on
scale 20.000 LBS
ENTER
-- CAL DATA SCROLL 7 --
WEIGHT CAL constant
00.00
MENU RUN
-- CAL DATA SCROLL 8 --
CALIBRATION interval
365 Days
ENTER
Password:
Service
Password:
Operator
A-30 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B