Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.7.1.1 Defining the R-Cal Parameters
This section only applies of R-Cal mode was selected as the preferred method.
Enter the resistance in Ohms of the R-cal resistor installed in your Integrator.
Default value installed is 165000 Ohms. See the Data Sheet in front of this
manual for exact resistance.
-- CAL DATA SCROLL 2 --
R-CAL select
Res 165000 ohms
ENTER
Default: 165000 Ohms
Min: 10 Ohms
Max: 1000000 Ohms
The system calculates the CALCON (Calibration Constant) based on the
mechanical and electrical parameters entered in SCALE DATA. This menu is
for reference only.
-- CAL DATA SCROLL 3 --
R-CAL constant
00.00
MENU RUN
A.7.1.2 Defining the Chains Parameters
This section only applies if CHAINS mode was selected as the preferred
method. Enter the weight per foot or meter of the chains used for calibration.
-- CAL DATA SCROLL 4 --
R-CAL constant
00.00
MENU RUN
Password:
Service
Password:
Service
English/Mixed Metric
Default: 0.000 Lbs/Ft Default: 0.000 kg/m
Min: 0.000 Lbs/Ft Min: 0.000 kg/m
Max: 1000.000 Lbs/FT Max: 3000 kg/m
The system calculates the CALCON based on the mechanical and electrical
parameters entered in SCALE DATA. This menu is for reference only.
-- CAL DATA SCROLL 5 --
CHAIN CAL constant
00.00
MENU RUN
Thermo Fisher Scientific Weighbridge Physical Parameters A-29
REC 4175 Rev B