Thermo Ramsey - Hoferick Engineering GmbH

Menus
If R-CAL, WEIGHTS, or CHAINS is pressed, the following screen displays:
XXXX MAT’L FACTOR
New factor 000.00 %
Change factor?
ADV YES NO
Adv – ADVANCES TO THE OLD FACTOR AND AGAIN TO THE
NEW FACTOR
No – SELECT no IF THE ACQUIRED MATERIAL FACTOR IS NOT
DESIRED.
Yes – select YES if this specific simulated method of calibration has already
been used and the related material factor will be recorded. This selection
advances to the next scroll.
The system is able to execute accurate calibrations in the future with this
simulated method. The following screen displays:
XXXX MAT’L FACTOR
Old factor 000.00 %
New factor 000.00 %
RUN MENU FACTOR
FACTOR – repeats for all simulated tests previously run.
RUN or MENU – if RUN or MENU is selected, the following screen displays:
MAT’L CALIBRATION
Add reference
weight to totals
YES NO
XXXX = R-CAL,
WEIGHTS, or CHAINS
XXXX = R-CAL,
WEIGHTS, or CHAINS
YES – the amount of material used for the test is added to the master, reset,
and operator’s totals.
NO – the information is lost
Note: Moisture compensation is inhibited during material calibration. This is
done to make the check of the totalized quantity easier. The static scale
provides the weight of the material including moisture. The weight of the water
is removed immediately before adding to total at the end of the procedure, so the
Master, Reset, and Operator’s totals are still correct.
Thermo Fisher Scientific Weighbridge Physical Parameters A-15
REC 4175 Rev B