Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.3.7. Updating the Span Constant
After the amount of material has been entered, the following screen displays:
MAT’L CAL. COMPLETE
Error 000.00 %
change span?
YES NO ADV
Complete flashes
YES – moves to the following screen
ADV changes from Error % to Actual Difference of Total
NO moves to the following screen:
MAT’L CALIBRATION
Add reference
weight to totals?
YES NO
YES – the reference weight is added to the totals and the Integrator returns
to MAIN MENU 1
NO – returns to MAIN MENU 1
A.3.8. Acquiring the Material Factors
If yes was selected at the Updating the Span Constant screen, the following
screen displays confirming the new span constant was installed.
SPAN # CHANGED
New span # 000000
Old span # 000000
RUN MENU FACTOR
At this point, the scale is calibrated to the actual material test.
RUN – returns to the RUN main menu
MENU – returns to MAIN MENU 1
FACTOR – Of the three simulated load calibration methods, only the ones that
have been already used are shown. It is not possible to calculate a material
factor if a simulated test was not run before the material test. The following
screen displays:
MAT’L CALIBRATION
Automatic correction
to Material Factors
R-CAL WTS CHAIN
If none of the three was performed, FACTOR is not displayed.
A-14 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B