Thermo Ramsey - Hoferick Engineering GmbH

Menus
4. Press CONTINUE
The following screen displays:
00000.0 Tons
0000.0 Tph
Press DONE to end
DONE ABORT
During the Material Calibration procedure, the resolution of total tons
counted is ten times higher than normal.
5. Wait until all material has passed over the scale, press DONE.
ABORT forces the program back to the top of the MATL CAL scroll.
A.3.6. Entering the Reference Weight
At the end of the test, the system asks the operator whether the (actual) weight
of material is already known.
0000.00 Tons
Ref. Weight known?
YES NO
NO – select no if the reference (actual) weight is not known for some time and
the conveying systems need to be returned to run.
The RUN screen displays MAT’L flashes to remind the operator that the
material test is incomplete.
Press MAT’L when the reference weight is known and the following screen
displays:
0000.00 Tons
Enter reference
weight 00.0 Tons
ENTER ABORT
YES – if the operator selected yes, the screen above displays.
1. Enter the actual material weight in the same weight units, as the Integrator
is setup to use.
Example: Convert pounds to nearest hundredth (0.01) of a ton and enter
the result if the Integrator is set up for tenths (0.1) of a ton increments.
Material Calibration is running at 10 times normal.
2. Press ENTER
ABORT – if abort is selected the information acquired during the test is
lost and the system returns to MAIN MENU 1.
Thermo Fisher Scientific Weighbridge Physical Parameters A-13
REC 4175 Rev B