Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.3.3.6 Recording New Span
The Integrator calculates the new span based on the result of the test performed
with the simulated method.
AUTO SPAN COMPLETE
Error +/-00.00 %
Change span?
YES NO ADV
Complete is flashing
ADV – advances to Accumulated Weight, Cal Con, Material Factor, and back to
Error %.
YES – if the operator selects YES, the following screen displays:
Note: If the Material Factor is invalid (never acquired before), it is not
displayed.
SPAN # CHANGED
Old span #: 00000
New span #: 00000
RUN REPEAT ADV
RUN – returns to the RUN main menu
REPEAT – moves back to Section 3.10.3.1.4 and calibration restarts
ADV – changes from Error % to Accumulated Weight, Calcon, Old Span,
and Material Factor (if not invalid).
NO – If the operator selects NO, the following screen displays:
SPAN UNCHANGED
Old span #: 00000
New span #: 00000
RUN REPEAT ADV
RUN – returns to the RUN main menu
REPEAT – moves back to Section 3.10.3.1.4 and calibration restarts.
ADV – changes from Error % to Accumulated Weight, Calcon, Old Span,
and Material Factor (if not invalid).
Note: The Old Span and New Span are equal because no change has been made
to the span.
A-10 Weighbridge Physical Parameters Thermo Fisher Scientific
REC 4175 Rev B