Thermo Ramsey - Hoferick Engineering GmbH

Menus
A.3.3.3 Starting a Test Weights Calibration
Use the following steps to begin a Test Weights Calibration:
1. Stop the conveyor belt if necessary to apply test weights.
2. Press SPAN CAL
The following screen displays:
AUTO SPAN Weights
Press START to begin
weight calibration.
START EXIT MANUAL
3. Press START to disengage the Master Tons counter.
The following screen displays:
AUTO SPAN Weights
Apply weights, then
press START.
START EXIT MANUAL
If LOAD WTS output was selected in the I/O Definition Scroll, test weights
are automatically loaded after START is pressed. Wait for test weights to be
loaded before proceeding. The following message displays:
AUTO SPAN Weights
Press START to load
test weights.
START EXIT
EXIT returns the screen to MAIN MENU 1
4. Apply test weights
5. Press START
The following screen displays:
AUTO SPAN Weights
Run belt, then
press START.
START EXIT
Password: Operator
Password: Operator
Password: Operator
Thermo Fisher Scientific Weighbridge Physical Parameters A-7
REC 4175 Rev B