Thermo Ramsey - Hoferick Engineering GmbH
Thermo Ramsey - Hoferick Engineering GmbH
Thermo Ramsey - Hoferick Engineering GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Replacement Parts<br />
5. High Load<br />
The belt load has been detected to be higher than the maximum belt loading<br />
entered in the ALARM SET UP menu.<br />
6. Low Load<br />
The belt load has been detected to be lower than the minimum belt loading<br />
entered in the ALARM SET UP men.<br />
7. High Rate<br />
The rate has been detected to be higher than the maximum rate entered in<br />
the ALARM SET UP menu.<br />
8. Low Rate<br />
The rate has been detected to be lower than the minimum rate entered in the<br />
ALARM SET UP menu.<br />
9. High Speed<br />
The speed has been detected to be higher than the maximum rate entered in<br />
the ALARM SET UP menu.<br />
10. Low Speed<br />
The speed has been detected to be lower than the minimum speed entered in<br />
the ALARM SET UP menu.<br />
11. Warm Start<br />
The system has detected a power loss condition, or power was removed for<br />
an undefined period.<br />
12. Cold Start<br />
The system has detected the loss of the set up data after power was<br />
removed. The instrument needs to be setup and calibrated.<br />
Replace the motherboard<br />
Note: The message COLD START never appears on the screen. This is<br />
because a Cold Start forces a start up procedure to be executed, and the alarm<br />
itself is cleared after the se up is completed. However, the alarm LED and the<br />
digital output will be showing an alarm during the initial set up procedure.<br />
13. P.D. Calibrate<br />
When the system is powered off while a calibration sequence is in progress,<br />
the scale may not be properly calibrated.<br />
Check calibration<br />
<strong>Thermo</strong> Fisher Scientific Replacement Parts<br />
REC 4175 Rev B<br />
4-3
Change language