Thermo Ramsey - Hoferick Engineering GmbH

Maintenance
3-22
At this point, the scale is calibrated to the actual material test.
Run: returns to the RUN main menu
Menu: returns to MAIN MENU 1
Factor: Of the three simulated load calibration methods, only the ones that
have been already used are shown. It is not possible to calculate a material
factor if a simulated test was not run before the material test. The following
screen displays:
MAT’L CALIBRATION
Automatic correction
to Material Factors
R-CAL WTS CHAIN
If none of the three was performed, FACTOR is not displayed.
• If R-CAL, WEIGHTS, or CHAINS is pressed, the following screen displays:
XXXX MAT’L FACTOR
New factor 000.00 %
Change factor?
ADV YES NO
ADV: advances to the Old Factor and again to the New Factor
NO: select NO if the acquired material factor is not desired. This selection
returns to Section 8
Yes: select YES if this specific simulated method of calibration has already
been used and the related material factor will be recorded. This selection
advances to the next scroll.
The system is able to execute accurate calibrations in the future with this
simulated method. The following screen displays:
XXXX MAT’L FACTOR
Old factor 000.00 %
New factor 000.00 %
RUN MENU FACTOR
XXXX = R-CAL,
WEIGHTS, or CHAINS
FACTOR: repeats for all simulated tests previously run.
RUN OR MENU: if RUN or MENU is selected, the following screen displays:
9. Adding the Reference Weight to Total
MAT’L CALIBRATION
Add reference
weight to totals
YES NO
XXXX = R-CAL,
WEIGHTS, or CHAINS
Maintenance Thermo Fisher Scientific
REC 4175 Rev B