manual MAPV2 eng - Audionet

Note:
• The Progressive Scan Card will process only interlaced video signals!
Connection diagram YUV Video In:
If your video source has a Component or YUV video output, connect the three lines Y,
U and V to the MAP V2 according to the diagram:
This unit must be earthed.
This unit must be earthed.
VGA
OUT
VGA
OUT
OUT OUT OUT
Y/R C /G C /B
R B
IN IN IN
OUT OUT OUT
Y/R C /G C /B
R B
IN IN IN
IN 1
Audionet EPS only.
IN 1
Audionet EPS only.
IN 2 IN 3 IN 4
VIDEO IN
IN 2 IN 3 IN 4
VIDEO IN
43
NEG.
NEG.
OUT 1 OUT 2
VIDEO OUT
(OSD)
S-VIDEO 1 S-VIDEO 2 S-VIDEO 3 S-VIDEO 4 S-VIDEO 1 S-VIDEO 2
ANALOG OUTPUTS
Y U V from video output of video source
OUT 1 OUT 2
VIDEO OUT
(OSD)
S-VIDEO 1 S-VIDEO 2 S-VIDEO 3 S-VIDEO 4 S-VIDEO 1 S-VIDEO 2
(Vsync)
(Vsync)
ANALOG OUTPUTS
(Hsync)
(Hsync)
OPTICAL
DIGITAL
OUT
Connection diagram RGB Video In:
If your video source has a RGB video output, connect the four lines R, G, B and C-Sync
to the MAP V2 according to the diagram:
R G B C-Sync from video output of
video source (Cinch)
from video output of
video source (SCART)
left
OPTICAL
DIGITAL
OUT
left