manual MAPV2 eng - Audionet

Set Video Input:
This it the same function as in the Channel Setup menu. It's also integrated here for
easier access.
Note:
• The video input setting applies to each audio input channel independently! All other
video settings are set globally.
Set TV System:
For correct conversion from cinch video to S-Video please select the corresponding TV
System. Press Vol- key for NTSC. Press Vol+ for PAL.
All other items in the Video Setup menu relate to an optional Progressive Scan Card.
Please refer to chapter 'Progressive Scan Card'.
Menu Bass Manager
Use items in the Bass Manager menu to match the MAP V2 to the speakers in your
system. Navigate through the menu using keys Ch+ / Ch- , select options with keys
Vol- / Vol+ .
Set Speakers:
Speaker settings are adjusted by channel groups:
Front = Front Left and Right
Center = Center
Surr = Surround Left and Right
Back = Back Left and Right
First, choose the method how the bass of the selected channel group is reproduced:
None: speaker(s) of this channel group is/are not available.
Small: Bass below the crossover frequency (X-Over Freq) is redirected to
subwoofer channel or to any speaker selected as Large, if no Subwoofer
is available. Please use this option for small speakers, that are not capable
of reproducing frequencies below the crossover frequency.
Large: the speaker(s) of this channel group reproduce the full frequency range.
Select this option, if your speakers are able to reproduce bass below the
crossover frequency.
X-Bass: same as Large, but additionally the bass below the x-over frequency of
this channel group is re-routed to the Subwoofer. Use this setting if you
want to drive your speaker in full range, but also create a stronger bass
foundation.
Note: As now the speaker(s) of this channel group and the subwoofer
35