manual MAPV2 eng - Audionet

Screen page 6
Fri 12:45
MAP V2
1 Setup
Manager
2
Video
5 Test Tone
6
8
Channel
Global
Setup
3 4
Setup
6 OF 9
1 Channel Setup enters the Channel Setup menu.
2 Global Setup enters the Global Setup menu.
3 Video Setup enters the Video Setup menu.
4 Bass Manager enters the Bass Manager menu.
5 Delay Manager enters the Delay Manager menu.
6 Press key TestTone to start the internal test tone generator. The generator
delivers a noise signal to the Front Left channel. You can now adjust the reference
level with keys Vol- / Vol+ as described above. Press key Ch- to produce the
noise signal in the next channel. Or use key Ch+ to skip back to the previous
channel. Ch- moves the noise signal clockwise (according to your speaker
positions in your listening room) from one channel to the other, Ch+ selects the
channels anti clockwise. Adjust the level of each selected channel so that all
channels reproduce the noise signal of the test tone generator with the same volume.
Press TestTone again to switch off the test tone generator and return to RUN
mode.
Note: No test tone is available on the Subwoofer output!
7 Number of current screen page and total number of pages
(example: '6 OF 9' → screen page 6 of 9).
8 Skips back to the previous screen page (see user's manual Harmony 785).
9 Advances to the next screen page (see user's manual Harmony 785).
For further details on the setup menus please refer to section 'Setup'.
Screen page 7
All 8 keys on screen pages 7 and 8 are used to configure the parametric, digital
equalizer. If the MAP V2 is in any other mode than the setup mode for the equalizer,
22
Bass
Delay
Manager
7
9