Technical documentation

More documents

Recommendations

Info

W.E.ST. Elektronik GmbH LOADBACK (copy of the EEPROM into the active RAM) Commands Parameter Defaults Units loadback - - - With this command, the data will be written back from EEPROM to RAM. This is helpful when the previous control parameter (before the last saving) will be reactivated. DEFAULT (parameter reset) Commands Parameter Defaults Units default - - - Reset of all parameters to the set in factory definition. Data not stored in EEPROM. PROCESS DATA (monitoring) Commands Parameter Units w Demand value 0,01% x Actual value xw Control deviation v Velocity u Actuator signal The process data can be read out now. They show the actual and command values. Seite 22 von 24
W.E.ST. Elektronik GmbH Appendix: Power stage (PEXT3) Description of the integrated power stage see: Pext3.PDF Seite 23 von 24
Page 1 and 2: W.E.ST. Elektronik GmbH Technical d
Page 3 and 4: Revisions W.E.ST. Elektronik GmbH D
Page 5 and 6: General installation remarks Explan
Page 7 and 8: In- and outputs W.E.ST. Elektronik
Page 9 and 10: Typical wiring PLC Inputs PLC Outpu
Page 11 and 12: W.E.ST. Elektronik GmbH General IO
Page 13 and 14: W.E.ST. Elektronik GmbH As current
Page 15 and 16: Parameter table W.E.ST. Elektronik
Page 17 and 18: D (deceleration stroke or braking d
Page 19 and 20: W.E.ST. Elektronik GmbH TH (Stroke
Page 21: INPOS (in positioning window) W.E.S

Technical documentation

Create successful ePaper yourself

Delete template?

Save as template?