Cable Winch Brochure - Werner GmbH Forst- und Industrietechnik

TECHNCIAL SPECIFICATIONS
Cable wind up: Werner cable winches are equipped with
a cable guide housing and a spooler over a cross-wind
threaded spindle. This allows a minimum wear of the
cable and an optimal use of the cable drum volume. A
direct angular traction force can be used with an installation
at the back or the front of the vehicle.
Releasable with a load: Forestry cable winches made by
Werner can be released with a load. To avoid damage
to the equipment during its use with downward loads,
the brakes can be opened by pressure and the loads
released. The cable drum can also be completely separated
from the gear unit by using the drum neutral position –
this makes the cable pull out considerably easier.
Hydraulic cable supply: Especially with winches which
have been installed at the front or back of a vehicle, the
hydraulic supply device used to pull out the cable functions
with a minimum of force. The hydraulic cable supply
compensates the friction drag of the defl ection pulleys
and the cable bedding. A fi rmer adjustment of the sliding
brake prevents a trailing of the cable on the drum. The
cable wind up under initial stress prevents loose cable
from gathering on the drum.
Position-dependent control: The use of Werner cable
winches with a position-dependent control allows the
respective cable position to be exactly established while
in operation. The electro-hydraulic or elec tronic control
assures a consistent lifting power over the whole length
of the cable.
11