Cable Winch Brochure - Werner GmbH Forst- und Industrietechnik

More documents

Recommendations

Info

06 TAILORED INSTALLATION 07
MEETING CHALLENGES We also design optimal customised solutions when dealing with the narrow confi nes of the chassis of a Unimog. The photograph shows the complex job of combining a winch with the frame area tog ether with a rear power take-off shaft. Since the conditions of the structural space following the introduction of the EURO 4 do not permit a side installation anymore, the winch had to be integrated with the frame. Such a superstructure cannot be integrated into a standard platform. This is why Werner made a winch with an exact fi t and implemented a solution which allowed for an installation to the frame according to the customer’s requirements. The Unimog U 500 in the photograph has been designed by Werner for a special use in the energy sector. The customer wished to combine a hydraulic cable winch with numerous other pieces of equipment on a vehicle possessing a short wheel base. Along with a front compressor and a work basket on the platform, this U 500 also features a crane superstructure and a slope support. Despite the crane frame recesses the cable course leads from the winch installed at the side of the vehicle and through the frame to the back. Combined with the crane frame this conversion was a special engineering and design feat by Werner not the least because of the short chassis.
Page 1 and 2: CABLE WINCHES
Page 3 and 4: Tradition Ideas Craft Ability CRAFT
Page 5: 1 3 TAILORED INSTALLATION Because w
Page 9 and 10: TECHNCIAL SPECIFICATIONS Cable wind
Page 11 and 12: 1 2 13
Page 13 and 14: 1 2 PULLING Traction cable winches
Page 15 and 16: 1 2 17
Page 17 and 18: Mechanical winches Winch type Tract

Cable Winch Brochure - Werner GmbH Forst- und Industrietechnik

Create successful ePaper yourself

Delete template?

Save as template?