Digipass Plug-In for SBR Administrator Reference - Vasco

Digipass Plug-In for SBR Administrator Reference Active Directory Schema
2.3.2 Using the Custom Search for Digipass
To perform a search for Digipass:
1. Right-click on the Organizational Unit in which to search, or the domain root.
2. Click on Find...
3. Select the Digipass object type from the Find: drop down list.
4. Use the Digipass tab to specify the search criteria. Almost all the Digipass search
criteria can be set using the form on this tab.
5. If you are searching on any criteria that do not appear on the Digipass tab, use the
Advanced tab:
a. Click on the Advanced tab.
b. Click on Field and select the required attribute from the list.
c. Enter the search Condition and Value, then click Add.
d. Repeat with additional Fields.
6. Click Find Now to execute the search. Multiple criteria are applied using the logical
AND – all criteria must be met for a Digipass to be found.
The available criteria are listed in the following table:
Table 5: Custom Active Directory Search criteria - Digipass
Tab Field Name Usage
Digipass Serial Number Exact Serial Number (as seen in Digipass properties);
Serial Number with wildcard*;
First Serial Number in range, when used with To field.
(Serial Number) To Last Serial Number in range.
Digipass Type Digipass Type, eg. DP300. Wildcard* allowed.
Application Name Application Name, eg. GO3DEFAULT. Wildcard* allowed.
This will find Digipass that have an Active application of the
specified name**.
Application Type Application Type: Response Only, Challenge/Response.
This will find Digipass that have an Active application of the
specified type**.
Digipass Assignment Assignment status: Assigned, Unassigned.
Reserved Reserved status: Reserved, Not Reserved.
Advanced Application Name Conditions: Starts with, Ends with, Is (Exactly), Is Not.
Values: Application Name (complete or partial)
This will find Digipass that have an Active application of the
specified Application Name criteria**.
Application Type Conditions: Is (Exactly), Is Not.
Values: RO (Response Only), CR (Challenge/Response), SG
(Signature).
This will find Digipass that have an Active application of the
specified Application Type criteria**.
Backup Virtual Digipass Enabled Conditions: Less than or equal to, Greater than or equal to, Is
(Exactly), Is Not, Not Present.
Values: 0 (Default), 1 (No), 2 (Yes - Permitted), 3 (Yes -
Required), 4 (Yes – Time Limited).
Note that Digipass with 'Default' for this setting may either have 0
© 2006 VASCO Data Security Inc. 22