Tbm dv8r manual - Troy Built Models
Tbm dv8r manual - Troy Built Models Tbm dv8r manual - Troy Built Models
4) Install overflow fitting. It goes off to the right in the photo below, through the fuselage. The overflow/startup tank then can rest on the wing. 5) Plumb tanks as shown. There is plenty of room to add a smoke tank in front of these tanks if desired. 6) Attach the TBM BFT (bubble-less fuel tank or equivalent) to the BFT mount and glue in place with Hysol where shown. 8
TBM BFT has Velcro hot glued to the tank. A band of one-wrap Velcro hold it in place. After the assembly is completed, glue in place as a unit. See next photo for placement. 9
- Page 1 and 2: TBM DV8R MANUAL Revised 1/4/2010 NO
- Page 3 and 4: Engine selection - Please READ! The
- Page 5 and 6: Photo of SWB 1” servo arm using t
- Page 7: 2) Push the two halves together and
- Page 11 and 12: Photo of another pilot’s layout o
- Page 13: term storage. If you prefer to glue
- Page 16 and 17: 3) Install included hardware. Use 2
- Page 18: 2) Use 48” servo extensions with
- Page 21 and 22: Rudder servo hatches moved to the f
- Page 23 and 24: Original style rudder servo mounts.
- Page 25 and 26: components have been installed for
- Page 27 and 28: RETRACT AND BRAKES The wing is alre
- Page 29 and 30: a. Photo of bulkhead fittings and a
- Page 31 and 32: Photo of the aileron servo mounting
- Page 33 and 34: Photo of the left vertical fin and
- Page 35: Elevators Full Rate……………
TBM BFT has Velcro hot glued to the tank. A band of one-wrap Velcro hold it in place. After<br />
the assembly is completed, glue in place as a unit. See next photo for placement.<br />
9