Tbm dv8r manual - Troy Built Models
Tbm dv8r manual - Troy Built Models Tbm dv8r manual - Troy Built Models
Photo of engine rails. These will need to be cut down for larger turbines. Use a drum sander and a vacuum cleaner to remove material. CANOPY The canopy can be painted as shown or not painted. You can have one pilot or two if you prefer. There are many options. Simply paint the outside of the canopy by masking off the area. Using black or silver paint from the hardware store is adequate. Fuel should not get onto the canopy. 26
RETRACT AND BRAKES The wing is already cut out for the TBM retracts. Test fit the retracts in place. Modify the mounts if necessary. Screw the retracts to the blocks provided. 27
- Page 1 and 2: TBM DV8R MANUAL Revised 1/4/2010 NO
- Page 3 and 4: Engine selection - Please READ! The
- Page 5 and 6: Photo of SWB 1” servo arm using t
- Page 7 and 8: 2) Push the two halves together and
- Page 9 and 10: TBM BFT has Velcro hot glued to the
- Page 11 and 12: Photo of another pilot’s layout o
- Page 13: term storage. If you prefer to glue
- Page 16 and 17: 3) Install included hardware. Use 2
- Page 18: 2) Use 48” servo extensions with
- Page 21 and 22: Rudder servo hatches moved to the f
- Page 23 and 24: Original style rudder servo mounts.
- Page 25: components have been installed for
- Page 29 and 30: a. Photo of bulkhead fittings and a
- Page 31 and 32: Photo of the aileron servo mounting
- Page 33 and 34: Photo of the left vertical fin and
- Page 35: Elevators Full Rate……………
RETRACT AND BRAKES<br />
The wing is already cut out for the TBM retracts. Test fit the retracts in place. Modify the mounts if<br />
necessary. Screw the retracts to the blocks provided.<br />
27