Tbm dv8r manual - Troy Built Models
Tbm dv8r manual - Troy Built Models Tbm dv8r manual - Troy Built Models
5) Remove covering and glue wood to wood to glue rudders in place. 22
Original style rudder servo mounts. Don’t use these. This photo shows the covering removed for gluing the rudders to the fuselage. So the same for the elevators. 6) If you use the inner hole on the SWB arms, then set the horns about 13/16” away from the surface from the rudder. 23
- Page 1 and 2: TBM DV8R MANUAL Revised 1/4/2010 NO
- Page 3 and 4: Engine selection - Please READ! The
- Page 5 and 6: Photo of SWB 1” servo arm using t
- Page 7 and 8: 2) Push the two halves together and
- Page 9 and 10: TBM BFT has Velcro hot glued to the
- Page 11 and 12: Photo of another pilot’s layout o
- Page 13: term storage. If you prefer to glue
- Page 16 and 17: 3) Install included hardware. Use 2
- Page 18: 2) Use 48” servo extensions with
- Page 21: Rudder servo hatches moved to the f
- Page 25 and 26: components have been installed for
- Page 27 and 28: RETRACT AND BRAKES The wing is alre
- Page 29 and 30: a. Photo of bulkhead fittings and a
- Page 31 and 32: Photo of the aileron servo mounting
- Page 33 and 34: Photo of the left vertical fin and
- Page 35: Elevators Full Rate……………
Original style rudder servo mounts. Don’t use these. This photo shows the covering removed for<br />
gluing the rudders to the fuselage. So the same for the elevators.<br />
6) If you use the inner hole on the SWB arms, then set the horns about 13/16” away from the<br />
surface from the rudder.<br />
23