CADD Engineering Standards - Ohio Department of Transportation

(1) Project Name: For this example, this field would be nnnnn_Design.
January 18, 2013
(2) Working Directory: Used to specify the default directory that GEOPAK will use to open and save
files. For this example this field would be set to \project\FRA\12345\geopak\
(3) Job Number: This is used to identify the Coordinate Geometry (COGO) Database (gpk) for the
project.
Use the three digit number for the mainline route number. For example, State Route 4 the Job
Number would be 004, Township Road 50 would be 050, etc.
In cases where there is not an established route number, the first three characters of the road
name should be used.
(4) The Project Description field shall contain the following information.
County-Route-Section: FRA-070-0.00
PID Number: 12345
State Job Number: 555555*
Project Manager: Ms. Jane Doe
Project Designer: Mr. John Dow
Project Description: The scope of work for project 12345 goes here. Include
as much detail as necessary to define the work done for
the project.
* If the State Job Number (SJN) is not assigned at the time of creation, leave the area blank where the
number is required. Update this field when SJN number is assigned.
In the middle of the Create New Project dialog, select the Preferences button to access the GEOPAK
User Preferences dialog. The values shown below are the recommended settings for an English unit
project.
ODOT CADD Engineering Standards 87