QUICK START GUIDE (for Eagle Point software)

More documents

Recommendations

Info

QUICK START GUIDE (for Eagle Point software) NODE (Field Code) LIBRARY – Attribute Styles By establishing the three different attribute styles and utilizing the layers created by using the established field codes, the user should be able to freeze and thaw selected layers to ease the drawing of various line features (e.g., profiles, breaklines, boundaries, etc.). Below is an example of this. This is a typical plot of survey points. It can lay over the top of each other, be very cluttered and difficult to “connect the dots” if trying to draw any linework. The V.FCOD.CLIN layer represents the centerline symbol. So, for this example, if you were to freeze all the V.FCOD.* layers but V.FCOD.CLIN, only the “centerline” nodes would be displayed. The drawing would become less cluttered and it would be much easier to draw your centerline from node to node as shown in this figure. 3.10 CADD Note 3 05/2008
QUICK START GUIDE (for Eagle Point software) NODE (Field Code) LIBRARY Numeric Code Symbols Chart The figure below shows the symbols used for each numeric field code along with its default description. 05/2008 CADD Note 3 3.11
Page 1 and 2: QUICK START GUIDE (for Eagle Point
Page 7 and 8: PROCESS LIBRARY QUICK START GUIDE (
Page 9: QUICK START GUIDE (for Eagle Point
Page 15 and 16: DATA COLLECTION Edit formatted file
Page 17 and 18: DATA TRANSFER QUICK START GUIDE (fo
Page 19 and 20: COGO - Nodes Place Nodes QUICK STAR
Page 21 and 22: COGO - Nodes QUICK START GUIDE (for
Page 23 and 24: COGO Report QUICK START GUIDE (for
Page 25 and 26: SURFACE MODELING Managing surface m
Page 27 and 28: SURFACE MODELING Contours - preview
Page 29 and 30: PROFILES QUICK START GUIDE (for Eag
Page 31 and 32: ROADCALC QUICK START GUIDE (for Eag
Page 33 and 34: ROADCALC Extract Cross-Sections QUI
Page 35 and 36: ROADCALC Profiles QUICK START GUIDE
Page 39 and 40: ROADCALC - Run Design QUICK START G
Page 41 and 42: ROADCALC Plan and Profile Sheets QU
Page 43 and 44: ROADCALC QUICK START GUIDE (for Eag
Page 45 and 46: SITE DESIGN Calculate Volumes QUICK
Page 47 and 48: DRAFTING QUICK START GUIDE (for Eag

QUICK START GUIDE (for Eagle Point software)

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?