Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The K-<strong>FLEX</strong> pre-shaped flanges are formed by a sectioned body of<br />
elastomeric insulation already covered with <strong>IC</strong> <strong>CLAD</strong> sheet, in black<br />
or silver.They include an adhesive overlap for fixing the two parts<br />
along the seperating cut.<br />
A<br />
A)<br />
Glue the cut elastomeric edges with K420 adhesive.<br />
B)<br />
Apply the two perforated parts on the flange keeping in mind that the<br />
overlappings are part of the upper section, in order to turn the<br />
superimposition against water.<br />
C)<br />
Close the glued elastomer sides to seal the pre-shaped part.<br />
Remove the protective silicone paper of the overlap and fix the<br />
closure of the finishing.<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - FLANGE<br />
Finishing with K-<strong>FLEX</strong> pre-shaped flange<br />
already finished with <strong>IC</strong> <strong>CLAD</strong> sheet<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
B<br />
C<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - FLANGES 11<br />
5