Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
A)<br />
Cut a section of K-<strong>FLEX</strong> <strong>IC</strong> / IN <strong>CLAD</strong> sheet of a length corresponding to the<br />
surface of the insulated tube plus 5 cm of excess for the overlapping of the<br />
joining edges.<br />
B)<br />
Apply indented sheet on the underlying section of piping and glue the joining<br />
edges with the appropriate K 420 adhesive.The indentation should open up on<br />
contact with the lower disk of the flange b1).<br />
C)<br />
Cut out an indented ring (see reference on page 05) and apply it to the lower<br />
piping behind the flange disk, in a way that it closes the indentation of the sheet<br />
of the pipe previously placed.<br />
Abundance<br />
On the parts in contact with the flange, fix the disk with K 420 adhesive all along<br />
the delimitation areas of the diameters and of the cuts (c1).<br />
D)<br />
With the correct paste glue the indentation of the ring and bend it onto the<br />
body of the flange (d1 - d2).<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - FLANGE<br />
Flange finishing placed on vertical piping<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
A<br />
B C D<br />
b1<br />
c1-see pag. 05<br />
d1<br />
d2<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - FLANGES 08<br />
5
Change language