Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Finishing of the lateral disks<br />
A)<br />
Prepare two equal sections of <strong>IC</strong> / IN <strong>CLAD</strong> sheet<br />
and trace on each a indentated ring of a diameter<br />
corresponding to the disks of the flange a).<br />
The diameter b) defines the limit of the external profile of<br />
the indentation.<br />
The diameter of the hole c) corresponds to that of the pipe<br />
already finished on which the indentated ring should be installed<br />
The tracing should include a cut d) for the installation<br />
of the rings on the respective tube.<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - FLANGE<br />
Flange finishing placed on horizontal piping<br />
B)<br />
After having cut out the complete tracing of each ring,<br />
place it on the respective pipe so that it appears adherent<br />
a<br />
to the disk of the flange and covers the indentation of the sheet of<br />
the pipe previously mounted.<br />
B C<br />
a<br />
c<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
A<br />
b<br />
c<br />
d<br />
C) On the parts in contact<br />
with the flange, fix the disk<br />
with K 420 adhesive all along<br />
the delimitation areas of the<br />
diameters and of the cuts.<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - FLANGES 05<br />
5