Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
How to arrange the finishing shapes for the elbow.<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - ELBOWS<br />
Finishing of elbows with<br />
<strong>IC</strong> <strong>CLAD</strong> SR / BK sheet<br />
A) After having prepared an insulated elbow, pre-cut or completely prepared by the fitter, and having insulated the adjacent tubes, apply the finishing to the insulated tubes<br />
leaving an abbundance of 5 cm (A1-A2) to allow for the superimposition of the elbow finishing.<br />
B) Apply the sections of shaped <strong>IC</strong> <strong>CLAD</strong> SR (silver colour) or BK (black colour) sheet on the elbow. For the type of shape see the example on the following page.<br />
For the joints of the shapes, overlap the abundances prepared in advance “against water”, for this reason the mounting sequence of the shaped parts is carried out<br />
starting from the lowest part (see numbering 1-2-3-4,referring to an elbow finishing in 4 sections).<br />
A<br />
A2<br />
A1<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
B<br />
1<br />
2<br />
3<br />
4<br />
In the case of a different<br />
position of the elbow, especially<br />
on tubes installed externally,<br />
all the overlappings should be<br />
placed “against the water”.<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - ELBOWS 05<br />
3
Change language