Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
A)<br />
The finishing of the product is equiped with an adhesive overlap,<br />
with male-female extremities, to allow slotting into other tubes (A1).<br />
The pre-cut tube is also equipped with an adhesive overlap to close<br />
the longitudinal cut (A2)<br />
A1 A1<br />
B)<br />
Open the pre-cut tube and place it on<br />
the section of piping to be covered.<br />
Glue the cut edges of the elastomer<br />
with k 420 adhesive.<br />
The operation can be easily carried out even<br />
on a working bench.<br />
In that case the K <strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> tube will<br />
be installed on the piping ready to be closed.<br />
C)<br />
Leaving the longitudinal overlap free,<br />
join the edges of the elastomer applying<br />
the correct pressure to obtain an even<br />
adhesion, without stretch marks.<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - TUBE<br />
Pre-cut tube with SR o BK finishing already applied<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
A1<br />
A<br />
B<br />
C<br />
A2<br />
<strong>IC</strong> <strong>CLAD</strong> guida per l’applicazione 03/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - TUBES 19<br />
2