Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Circumference of the piping<br />
Laying of K-<strong>FLEX</strong> elastomeric insulating sheet<br />
Length of the insulation section<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - TUBE<br />
Insulation with K-<strong>FLEX</strong> elastomeric sheet or tube<br />
A)<br />
Cut from a K-<strong>FLEX</strong> insulating sheet a section corresponding to the dimensions<br />
of the piping to insulate and glue the joining edges with K 420 adhesive.<br />
Take the measurements of the circumference wrapping around the piping<br />
a strip of elastomeric insulation of the thickness that you are using.<br />
B)<br />
Place the sheet on the piping and close the longitudinal joints. Press the glued edges carefully together in order to<br />
obtain an even joint, without stretch marks.<br />
KEY: Adesivo K 420 Marine silicone Measurements Actions<br />
Laying of K-<strong>FLEX</strong> elastomeric<br />
insulation tube<br />
• Lay the insulation tube after having<br />
cut it lengthwise.<br />
• Close the tube again fixing the edges<br />
of the cut with K 420 adhesive.<br />
The laying procedure is the same as that illustrated<br />
for the K-<strong>FLEX</strong> sheet.<br />
<strong>IC</strong> <strong>CLAD</strong> guida per l’applicazione 03/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - TUBES 04<br />
2